Skip to main content

Check Throughput of Interfaces - Palo Alto Networks NGFW

Check Throughput of Interfaces - Palo Alto Networks NGFW

Following command shows brief interface throughput.
> show system statistics session
To see the complete statistics, run the show system state browser command
> show system state browser
Press Shift+L and click on Ports
To enable tracking and updates press Y and U
To see additional ports, press space bar

Comments

Post a Comment

Popular posts from this blog

CLI Commands for Troubleshooting FortiGate Firewalls

CLI Commands for Troubleshooting FortiGate Firewalls 2015-12-21 Fortinet , Memorandum , Network Cheat Sheet , CLI , FortiGate , Fortinet , Quick Reference , SCP , Troubleshooting Johannes Weber This blog post is a list of common troubleshooting commands I am using on the FortiGate CLI . It is not complete nor very detailled, but provides the basic commands for troubleshooting network related issues that are not resolvable via the GUI. I am not focused on too many memory, process, kernel, etc. details. These must only be used if there are really specific problems. I am more focused on the general troubleshooting stuff. I am using it personally as a cheat sheet / quick reference and will update it from time to time. Coming from Cisco, everything is “show”. With Fortinet you have the choice confusion between show | get | diagnose | execute . Not that easy to remember. It is “ get router info6 routing-table” to show the routing table but “ diagn...
Post a Comment
Read more

FortiGate: Upgrading the firmware via CLI

FortiGate: Upgrading the firmware via CLI To use the following procedure, you must have a TFTP or FTP server that FortiDB can connect to. You must also log in using the “admin” administrator account. Start the FTP or TFTP server. Copy the new firmware image file to the FTP or TFTP server. Log into the CLI. Verify that FortiDB can connect to the FTP or TFTP server. For example, if the IP address of the TFTP server is 192.168.1.168, enter the CLI command: execute ping 192.168.1.168 Enter the following command to copy the firmware image from the TFTP server to FortiDB: execute restore image ftp execute restore image tftp Where is the name and location of the firmware image file and or is the IP address of the FTP or TFTP server. For example, if the firmware image file name is image.out and the IP address of the FTP or TFTP server is 192.168.1.168, enter: execute restore image tftp image.out 192.168.1.168 FortiDB responds with the message: This oper...
Post a Comment
Read more